How to remove front and rear bumper VW LUPO

Front bumper

Depending on the year attachment locations can vary.

-under the hood, Unscrew the two screws on the edges of the grille.

-flat screwdriver, release the edges of the trim strips of the radiator grille (joint with wings).

-presses using a flat screwdriver on the clips in the lower part of the plate and remove the grille.

-Unscrew one screw on each side under grille (spun down).

-take out the caps in the lower grille (inserted from the bottom up) and Unscrew one screw at the edges.

-wrenched the wheel to the side depending on which side will disassemble the first.

-wheel arches wrenched the screws that attach the fender liner.

-with the assistant pulls the bumper forward from the rails.

-remove connector from the PDC (if any).

-disconnect hose of headlight washer system (if any). To from the reservoir was leaking fluid, you will need to drown out the hoses or tubes to bend.

-remove the connector from the fog lamp (if any).

Rear bumper

-open the boot lid in the opening, Unscrew one screw on each side that secure the tail lights.

-movement to the side and yourself remove the tail lights.

-under the rear lights Unscrew one screw on each side (twisted upside down).

-Unscrew the screws in the wheel arches(not to remove the wheel, remove ratchet with a nozzle).

-Unscrew the screws at the bottom of the bumper (spun up).

-With an assistant pulls the bumper back from the rails.

-remove the connectors from the light plate.

-remove connector from the PDC (if any).