How to remove front and rear bumper VW POLO (2001-2009)

Front bumper

Depending on the year attachment locations can vary.

-under the hood, Unscrew the two screws and take out the two clips that secure the grille.

-release the grille from the lower latches and remove upwards.

-Unscrew the three screws under the grille .

-remove side garnish grille (hold on clips) underneath and Unscrew one screw on each side.

-take out the caps at the bottom of the bumper (inserted from the bottom up).

-wrenched the wheel to the side depending on which side will disassemble the first.

-wheel arches wrenched the screws that attach the fender liner.

-with the assistant pulls the bumper forward from the rails.

-remove connector from the PDC (if any).

-disconnect hose of headlight washer system (if any). To from the reservoir was leaking fluid, you will need to drown out the hoses or tubes to bend.

-remove the connector from the fog lamp (if any).

Models after 2005, the changes are not significant.

If you have headlight washers, you need to remove their caps. To do this, take out the nozzles and release the lid latches.

Rear bumper

-in the trunk shifts side trim to the side (need to access the tail lights).

-Unscrew one nut on each side and remove the lights with the clips upwards.

-Unscrew the rear lights on the two screws on each side (twisted upside down).

-Unscrew the screws around the perimeter at the bottom of the bumper (spun up).

-Unscrew the screws in the wheel wells that secure the bumper to the wheel arches and rails(not to remove the wheel, remove ratchet with a nozzle).

-With an assistant, pull the bumper back from the guides.

-remove the connectors from the light plate.

-remove connector from the PDC (if any).

How to remove front and rear bumper VW POLO (up to 2001)

How to remove front and rear bumper VW POLO (after 2009)