-
-
-
Depending on the year of release of attachment is different.
Front bumper
The bumper is removed together with the iron amps.
-open the hood.
-under the hood, unscrew the screws (if any) is released from the latches and remove the grille.
-under the grille, unscrew the two screws that secure the amplifier to the body.
-wrenched the wheel depending on which side we understand.
-wheel arches unscrew the screws that attach the fender liner.
-remove the fender liner to the side and unscrew two screws on each side holding the bumper corners to the wings.
-around the bottom part unscrew the screws.
-unscrew the two screws behind the license plate.
-with the assistant pulls the bumper forward (don't want to break the wires).
-remove the connectors from the equipment (if any).
Rear bumper
-open the trunk lid.
-in the opening of the trunk, unscrew the screws that secure the upper part of the rear bumper.
-we release the side trim of the trunk.
-in the inside of the wings, Unscrew the screws that secure the sides of the bumper.
-wheel arches take out the caps that secure the fender liner.
-for the fender liner, Unscrew two screws on each side that secure the corners of the bumper to the wings.
-take out the caps (Unscrew the screws) from the bottom.
-with an assistant, gently pull the bumper back (be careful not to break the wires).
-disconnect electrical connectors (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español