How to remove front and rear bumper Mitsubishi Pajero / Montero III

Mitsubishi Pajero/ Montero III (1999-2006)

Depending on the year of manufacture, the attachment points may differ.

Front bumper

-open the hood.

-we release from the latches and remove the grille (with a thin flat screwdriver you need to press on the tail of the latch).

-under the grille, unscrew the three screws that secure the metal bumper reinforcement.

-turn the wheels, depending on which side we will disassemble.

-in the wheel wells take out the caps that secure the fender liner (front).

-remove the fender liner to the side and unscrew two screws on each side that attach the corners of the bumper to the wings and the amplifier to the brackets.

-around the bottom of the take out the caps and Unscrew the screws.

-with an assistant, pull the bumper forward (be careful not to break the wires and hoses).

-remove connectors from electrical equipment (if any).

-disconnect the headlight washer hoses (fluid may leak from the reservoir).

Rear bumper

-open the trunk lid.

-unscrew two screws on each side and remove the tail lights.

-unscrew the screws under the rear lights.

-in the opening of the trunk, unscrew the five screws and take out the four pistons.

-take out the caps and unscrew the screws around the perimeter of the lower part of the bumper.

-in the wheel wells, unscrew the screws and take out the caps that secure the fender liner and mud flaps.

-move the fender liner to the side and Unscrew one screw on each side that attach the corners of the bumper to the wings.

-with an assistant, pull the bumper back (look for the wires).

-disconnect electrical connectors.

How to remove front and rear bumper Mitsubishi Pajero (Montero/Shogun) 2 (1991-2004)

How to remove front and rear bumper Mitsubishi Pajero (Montero/Shogun) 4 (2006-2023)