Depending on the year of release of attachment is different.
Front bumper
-open the hood.
-in vehicles since 1999 take out the caps, Unscrew the screws and remove the grille. Until 1999, take out the clips that secure the upper part.
-on vehicles up to 1999 remove the turn signal, after a 1999 shooting lights.
-under the turn signal, Unscrew one screw on each side.
-wrenched the wheel to the side.
-in the wheel wells, Unscrew the screws (if any) and free lockers.
-for wheel arch liners Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.
-take out the rivets that attach the lower part.
-climb up under the car and Unscrew two screws on each side. Holding the iron amp bumper to the body.
-with the assistant pulls the bumper back.
Rear bumper
-open the trunk lid.
-in the trunk remove the trim panel.
-for casings, Unscrew the two nuts and two screws that fasten the bumper brackets to the body.
-Unscrew the screws that attach the side amplifiers to the wings.
-in the wheel wells, Unscrew the screws and peel the fender liner.
-Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.
-Unscrew the screws around the perimeter of the bottom.
-with the assistant gently pulls the bumper back.