Mitsubishi Lancer CX, CY, CZ (Lancer Evolution, Lancer Sportback) (after 2007)
Depending on the year of release, country of origin and the body type of the attachment is slightly different.
-open the hood.
-under the hood take out the caps and remove the cover plate and the intake.
-under the pad, Unscrew the five screws that secure the top.
-the bottom grille pull out the plugs and Unscrew under them two screws.
-wrenched the wheel to the side.
-wheel arches take out the caps and Unscrew the screws that attach the fender liner.
-attach the fender liner to the side and Unscrew one screw on each side holding the bumper corners to the wings.
-perimeter Unscrew the screws and take out the rivets that secure the lower part of the (twisted and inserted from the bottom up).
-we release the latch in the wings (pull the corners down and yourself) and under the lamps
-with the assistant gently pulls the bumper forward.
-if you have headlight washers, disconnected the hoses (may leak fluid).
-remove the connectors from the equipment (if any).
-open the trunk lid.
-in the opening of the trunk, Unscrew the two screws.
-in the wheel wells, Unscrew the screws, remove the caps and removed the mud flaps and the fender liner.
-for wheel arch liners Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.
-take out the caps on the perimeter of the bottom.
-we release the latch in the wings (pull the corners themselves).
-with the assistant gently pulls the bumper back.
-remove the connector from the lighting (if any)
-remove the connectors from the sensors (if any).