-
-
-
Depending on the year of release of attachment is different.
Front bumper
-open the hood.
-under the hood, Unscrew the screws and take out the clips that secure the grille and the upper bumper section.
-(depending on year) Unscrew the screws and take out headlights, under which we release the clamps.
-on the perimeter in the bottom part Unscrew the screws.
-wrenched the wheel depending on which way we will analyse it first.
-wheel arches vacated lockers and Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.
-with the assistant gently pulls the bumper itself.
-remove the connector from the fog lamp.
-remove connector from the PDC (if any).
Rear bumper
-open the trunk lid.
-in the trunk take out the clips and remove the trim panel.
for casings, Unscrew the screws (drawn in the diagram).
- Unscrew the four nuts on each side and take out the rear lights
-Unscrew the screws under the rear lights and opening boot.
-Unscrew the nut at the bottom.
-in the wheel wells, Unscrew the screws and peel the fender liner.
- Unscrew the screws (spun upwards) holding the corners of the bumper to the wings.
-with the assistant gently pulls the bumper itself.
-remove the connectors from the equipment (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español