The attachment points may differ depending on the year of manufacture and the type of body.
-open the hood.
-under the hood, take out the six rivets that secure the upper part of the bumper (lining).
-take out the caps and unscrew the screws from the bottom side.
-turn the wheels to the side.
-remove the wheel arch liners (front part).
-behind the wheel arch liners, Unscrew one screw on each side (twisted from bottom to top) that secure the corners of the bumper to the fenders.
-release the latches in the wings (pull the corners of the bumper towards you).
-with an assistant, we pull the bumper forward (we look behind the wires).
-disconnect the connectors of the electrical equipment (if any).
-open the trunk lid.
-in the opening of the trunk, unscrew two screws on each side and remove the taillights (they are held by the latches).
-under the rear lights, unscrew the screws and take out the caps.
-from the bottom, take out the caps and unscrew the screws.
-in the wheel arches, Unscrew three screws on each side that secure the wheel arch liners (rear part).
- (may not be) unscrew one screw on each side (twisted from bottom to top) behind the wheel arch liners, which attach the corners of the bumper to the wings.
-behind the bumper, from the bottom side, Unscrew the four bolts that secure the bumper reinforcement to the body.
-release the latches in the wings (pull the corners towards you).
-with an assistant, we pull the bumper back (look behind the wires).
-snap together the connectors for license plate lighting, parking sensors and cameras (if any).