The attachment points may differ depending on the year of manufacture.
Front bumper
-open the hood.
-under the hood, Unscrew the four screws (twisted from top to bottom) that secure the upper part of the bumper.
-Unscrew the six screws from the bottom side (screwed from bottom to top).
-wheel the wheels (depending on which side we will disassemble).
-in the wheel arches, Unscrew three screws on each side that secure the wheel arch liners (front part).
-behind the wheel arch liners, Unscrew one screw on each side (twisted from bottom to top) that secure the corners of the bumper to the fenders.
-release the latches in the fenders (pull the corners of the bumper towards you) and under the headlights.
-with an assistant, we pull the bumper forward (look behind the wires).
-disconnect the connectors of the electrical equipment.
Rear bumper
-open the trunk lid.
-in the opening of the trunk, remove the lining near the rear lights.
-the overlays, Unscrew two screws on each side and remove the taillights.
-under the rear lights, unscrew one screw and take out one piston on each side.
-in the wheel arches, Unscrew the screws that secure the wheel arch liners (rear part) and the sides of the bumper to the fenders.
-Around the perimeter of the lower part, take out the caps.
-further two options. 1 between the bumper and the body, take out two pistons (marked with a blue arrow, very difficult to access). 2 Unscrew the four screws that secure the bumper reinforcement to the body.
-release the latches in the wings (pull the corners of the bumper towards you).
-with an assistant, we pull the bumper back (look behind the wires).
-disconnect the connectors of the electrical equipment.