Depending on the model year and body type of attachment may vary.

Front bumper

-open the hood.

-under the hood, take out the three clips (inserted from top to bottom) that secure the grille and the upper bumper section.

-on the perimeter in the lower part and pull out the caps (inserted from the bottom up).

-wrenched the wheel depending on which side will parse the first.

-in the wheel wells, Unscrew the screws and peel the fender liner.

-attach the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.

-with the assistant release the latch in the wings, and gently pulls the bumper itself.

-remove the connectors from the fog lights (if any).

-remove connector from the PDC (if any).

the attachment of the front bumper for Hyundai Accent III (Verna) (2006-2010)

scheme of fastening of front bumper for Hyundai Accent III (Verna) (2006-2010)

Rear bumper

-open the trunk lid.

-in the trunk, behind the side panels, Unscrew the nuts and remove the rear lights.

-the rear lights take out the caps.

-on the perimeter in the bottom part Unscrew the screws.

-take out the caps on the perimeter at the bottom.

-wheel arches, peel the fender liner.

-move the wing flaps to the side and Unscrew one screw on each side (spun up), which attach the corners of the bumper to the wings.

-assistant free the bumper from the clips in the wings and gently pulls back.

-remove the electrical connectors (if any).

the attachment of the rear bumper for Hyundai Accent III (Verna) (2006-2010)

diagram of rear bumper for Hyundai Accent III (Verna) (2006-2010)

scheme of fastening of tail light Hyundai Accent III (Verna) (2006-2010)