How to remove front and rear bumper Honda Ridgeline

Front bumper

-open the hood.

-take out the three clips and remove the air intake.

-over grille pulls out the seven rivets and remove the panel above the grille.

-under the panel and pull out the clips that secure the upper part.

-under the car, Unscrew the six screws that secure the lower part.

-wrenched the wheel depending on which side we understand.

-wheel arches Unscrew the screws that attach the fender liner.

-for wheel arch liners Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.

-we release the latch in the wings and under the headlights (gently pull the corners to the sides and forward).

-with the assistant remove a bumper (watching not to cut wires).

-snap together the connectors of the equipment (if any).

Rear bumper

-open the back door.

-Unscrew two screws on each side and take out the rear lights.

-under the rear lights Unscrew one screw and take out one piston on each side.

-Unscrew the two screws in the aperture plate.

-in the wheel wells, Unscrew the screws holding the wheel arch liners (to turn the ratchet with the extension).

-Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.

-take out four of the pistons (inserted from the bottom up) that secure the lower part.

-we release the latch in the wings (pull the corners apart).

-with the assistant gently pulls the bumper back.

-remove plug with sensors and other equipment (if any).