-
-
-
Depending on body type, year of manufacture and the country of the manufacturer of the attachment may vary.
Front bumper
-open the hood.
-under the hood take out the caps released from the clips and remove the trim above the grille.
-under the pickguard, Unscrew the two screws that secure the top.
-perimeter of the lower part and pull out the caps (inserted from the bottom up).
-wrenched the wheel depending on which way we understand.
-wheel arches, peel the fender liner.
-attach the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.
-we release the latch in the wings and under the headlights (pull and go).
-pulls the bumper forward with the assistant.
-snap together the connectors of the equipment (if any).
-if you have headlight washers, disconnected the hoses (may leak fluid).
Rear bumper
-wheel arches Unscrew three screws on each side holding the wheel arch liners (easier to Unscrew the ratchet with a nozzle).
-remove the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.
-take out the two clips that secure the lower part (inserted from the bottom up).
-open the trunk lid.
-in the opening of the trunk pulls out a stub.
-under the plugs, Unscrew the screws.
-we release the latch in the wings, behind the rear lights and opening boot (pull on itself, and back).
-with the assistant gently pulls the bumper itself.
-remove the electrical connectors (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español