Honda Odyssey RB1, RB2 (2003-2008)

Depending on the year the site of attachment may vary slightly.

Front bumper

-open the hood.

-under the hood, take out nine of the caps (inserted upside down), is released from the latches and remove the cover plate over the grille.

-under the panel pull out the two clips that secure the upper part.

-around the bottom part pulls out six caps and Unscrew two screws (twisted and inserted from the bottom up).

-wrenched the wheel depending on which way we understand.

-wheel arches Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.

-with an assistant, carefully release the latches in the wings under the headlights (pull the corners to the sides and forward) and pulls the bumper forward.

-snap together the connectors of electrical equipment.

seat mounting front bumper, Honda Odyssey RB1, RB2 (2003-2008)

the scheme of fastening of a forward bumper for Honda Odyssey RB1, RB2 (2003-2008)

Rear bumper

-open the trunk lid.

-in the opening of the trunk take out the four plugs.

-under the plugs, Unscrew the screws.

-on the perimeter in the lower part and pull out the caps (inserted from the bottom up).

-wheel arches Unscrew two screws on each side holding the fender liner.

-for wheel arch liners Unscrew one screw on each side holding the bumper corners to the wings.

-carefully with the assistant release the latch in the wings (pull the corners away), pulls the bumper back.

-snap together the connectors of the equipment (if any).

the attachment of the rear bumper Honda Odyssey RB1, RB2 (2003-2008)

diagram of rear bumper Honda Odyssey RB1, RB2 (2003-2008)