Depending on the body type of the attachment may vary.
-open the hood.
-under the hood, take out the four clips that secure the upper part.
-around the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).
-wrenched the wheel depending on which way we understand.
-wheel arches, peel the fender liner.
-attach the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.
-we release the latch in the wings and under the headlights (pull towards you).
-pulls the bumper forward with the assistant.
-snap together the connectors of the equipment (if any).
-if you have headlight washers, disconnected the hoses (may leak fluid).
-wheel arches twist of guilt that attach the wheel arch liners (easier to Unscrew the ratchet with a nozzle).
-remove the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.
-take out the rivets that attach the lower part (inserted from the bottom up).
-open the trunk lid.
-in the opening of the trunk pulls out a stub.
under the plugs, Unscrew the screws.
-we release the latch in the wings, behind the rear lights and opening boot (pull on).
-with the assistant gently pulls the bumper back.
-remove the electrical connectors (if any).