-
-
-
Depending on the year of manufacture, the attachment points may differ.
Front bumper
-open the hood.
-under the hood we take out eighteen caps that secure the upper part of the bumper, a plastic trim and a seal over the headlights.
-around the perimeter of the lower part of the bumper, take out the seven caps and Unscrew the four screws (twisted and inserted from the bottom up).
-turn the wheels to the side.
-in the wheel wells, Unscrew two screws on each side that secure the fender liner (front) and the sides of the bumper.
-we release the latch in the wings (pull the corners of the bumper towards you).
-we release the plastic grille above the headlights (holds on latches).
-with an assistant, pull the bumper forward (look behind the wires and hoses).
-disconnect electrical connectors (if any).
-(if any) disconnect the headlight washer hoses.
rear bumper
-Open the trunk lid.
-in the opening of the trunk, Unscrew the two screws.
-on the perimeter of the lower part we take out eight caps.
-in the wheel arches, Unscrew three screws on each side that secure the fender liner (rear) and the sides of the bumper.
-we release the latch in the wings (pull the corners of the bumper towards you).
-we release the latches under the rear lights and in the opening of the trunk.
-with an assistant, pull the bumper back (look for the wires).
-disconnect electrical connectors (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español