Depending on the year the site of attachment may vary slightly.
-open the hood.
-under the hood take out the caps (inserted from top to bottom) that secure the panel above the grille (if any).
-take out the rivets that secure the grille.
-around the bottom part pulls out four piston and Unscrew the two screws (twisted and inserted from the bottom up).
-wrenched the wheel depending on which way we understand.
-wheel arches Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.
-with an assistant, carefully release the latches in the wings under the headlights (pull the corners to the sides and forward) and pulls the bumper forward.
-snap together the connectors of the fog lights (if any).
-open the trunk lid.
-in the opening of the trunk pull out four plugs and Unscrew the screws under them. Take out the caps (inserted upside down)
-on the perimeter in the lower part and pull out the caps (inserted from the bottom up).
-in the trunk openable hatches (to gain access to the rear part of the rear lights).
-through hatches, Unscrew four nuts on each side and remove the tail lights.
-Unscrew one screw on each side under the rear lights.
-wheel arches take out the rivets that attach the fender liner and Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.
-carefully with the assistant release the latch in the wings and under the tail lamps, bumper pulls ago.
-releasable connector Parking assist (if any).