-
-
-
Depending on body type, year of manufacture and the country of the manufacturer of the attachment may vary.
Front bumper
-open the hood.
-under the hood take out the seven rivets and Unscrew one screw that secure the cover plate over the grille.
-under the panel pulls out two pistons (inserted upside down)
-around the bottom part Unscrew four screws and remove two pistons (twisted and inserted from the bottom up).
-wrenched the wheel depending on which way we understand.
-wheel arches, peel the fender liner.
-for wheel arch liners Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.
-we release the latch in the wings and under the headlights (pull the corners in and forward).
-carefully, trying not to scratch the paint on the wings, pulls the bumper forward with the assistant.
-snap together the connectors of the equipment (if any).
-if you have headlight washers, disconnected the hoses (may leak fluid).
Rear bumper
-in the wheel wells, Unscrew the screws holding the mud flaps and arch liners (easier to Unscrew the ratchet with a nozzle).
-remove the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.
-(if you have one) take out the piston, which attaches the lower part (inserted from the bottom up).
-open the trunk.
-in the opening of the trunk take out the plugs and Unscrew the screws under them (four pieces).
-we release the latch in the wings and below the rear lights (pull on itself, and back).
-we release the latch in the opening of the trunk.
-with the assistant gently pulls the bumper back.
-remove connector from the PDC (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español