-
-
-
Depending on the model year and body type of attachment may vary.
Front bumper
-open the hood.
-under the hood take out the caps (eight or thirteen, depending on body type) and remove the pad (rests on the latch) on the radiator grille.
-around the bottom part pulls out ten rivets (inserted from the bottom up).
-wrenched the wheel depending on which way we understand.
-wheel arches Unscrew one screw on each side and removed the fender liner.
-we release the latch in the wings (pull the corners apart).
-release the clips under the headlights (sitting very tight), pull the corners to the sides and forward.
-pulls the bumper forward with the assistant.
-if you have headlight washers, disconnected the hoses (may leak the fluid).
-snap together the connectors of the equipment (if any).
Rear bumper
-wheel arches Unscrew the guilt that secure the wheel arches (turn off the ratchet with a nozzle).
-(may not be) remove the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners of the bumper to the wings.
in the middle of the bottom part pulls out with two clips (inserted from the bottom up).
-open the trunk lid.
-in the opening and pull out the plugs and Unscrew under them two screws.
-we release the latch in the wings (pull the corners apart).
-release the clips under the rear lights (pull the corners to the sides and back).
-we release the latch in the opening of the trunk and neatly with an assistant pulls the bumper back.
-remove the electrical connectors (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español