How to remove front and rear bumper Honda CR-Z

Front bumper

-open the hood.

-under the hood, Unscrew the screws and take out the caps, remove the pickguard (if any).

-under the panel and pull out the caps (inserted from top to bottom) that secure the upper part.

-around the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).

-wrenched the wheel depending on which way we understand.

-wheel arches, peel the fender liner.

-Unscrew two screws each side that attach the bumper corners to the wings.

-we release the latch in the wings and under the headlights (pull the corners in and forward) (if the clips under the headlights not wilkepedia, you need to pry with a flat head screwdriver).

-gently pulls the bumper forward with the assistant.

-snap together the connectors of the fog lights.

Rear bumper

-in the wheel wells, Unscrew the screws holding the wheel arches and bumper corners to the wings.

-take out the caps and Unscrew the screws that secure the lower part of the (twisted and inserted from the bottom up).

-open the trunk lid.

-in the opening of the trunk take out the plugs and Unscrew under them two screws.

-we release the latch in the wings and under the rear lights (pull the corners into themselves and back).

-we release the latch in the opening of the trunk.

-with the assistant gently pulls the bumper back.

-disconnected the electrical connector.