Depending on the model year and body type of attachment are different.

Front bumper

-open the hood.

-under the hood, take out the clips and remove the trim above the grille.

-under the pickguard, Unscrew the screws and take out the clips that secure the grille and the upper bumper section.

-Unscrew the screws and remove the headlamp.

-in the wheel wells, Unscrew the screws and take out the rivets that attach the fender liner.

-attach the fender liner to the side and Unscrew two screws on each side holding the bumper corners to the wings.

-around the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).

-we release the latch in the wings and under the headlights, carefully pulls the bumper forward.

-total releasable connector of electrical equipment.

-if you have headlight washers, disconnected the hoses (may leak fluid).

mounting locations for front bumper Ford Mondeo Mk4 (2007-2013)

the scheme of mounting front bumper Ford Mondeo Mk4 (2007-2013)

scheme of fastening of headlights Ford Mondeo Mk4 (2007-2013)

Rear bumper

-open the trunk lid.

-Unscrew the aperture screws (two or four, depending on body type).

-Unscrew the screws that attach the lower part (spun up).

-in the wheel wells, Unscrew the screws holding the wheel arch liners (to remove the wheels easier to turn the ratchet with the extension).

-remove the fender liner to the side and Unscrew two screws on each side holding the corners of the bumper.

-we release bumper latches in the wings (pull the corners themselves) and under the rear lights.

-with the assistant gently pulls the bumper back.

-remove the connector from the Parking assist sensors (if any) and light elements.

 the attachment of the rear bumper Ford Mondeo Mk4 (2007-2013)

scheme of fastening of a back bumper Ford Mondeo Mk4 (2007-2013)

scheme of fastening of a back bumper Ford Mondeo Mk4 (2007-2013)