Depending on the body type of the attachment is different.
-open the hood
-pull up mechanism of the handle of the hood lock (fixed by the latches).
-take out the four piston and Unscrew the two screws that secure the top.
-in the lower part pulls out six rivets (inserted from the bottom up) that attach the engine protection to the bumper. If you need to unprotect Unscrew the screws.
-wrenched the wheel depending on which way we will analyse it first.
-on each side Unscrew three screws in the wheel arches and three in the lower part (spun upwards) holding the fender liner.
-drawn wheel arches to the side, Unscrew two screws and take out one piston on each side (twisted and inserted from the bottom up) holding the corners of the bumper to the wings.
-with the assistant release the latch in the wings (pull the corners of the bumper itself) and under the headlights (if clicking does not work, you need to remove the headlights).
-gently pulls the bumper itself.
-remove the connector from the fog lamp (if any).
-remove the connector from the Parking assist sensors (if any).
-open the trunk lid.
-in the side panels openable hatches and Unscrew the two screws on each side that secure the tail lights.
-take out a rear lights (holding latches).
-in the opening of the trunk, Unscrew the two screws.
-Unscrew two screws each side in the wheel arches (so as not to remove the wheels easier to turn a ratchet with a nozzle).
-remove the fender liner to the side and Unscrew one screw on each side holding the corners of the bumper.
-(if any) Unscrew the screw at the bottom (spun up).
-with the assistant release the latch in the wings and under the tail lamps, gently pulls the bumper back.
-snap together the connectors for the sensors sensors (if any).