-
-
-
Front bumper
-under the hood near the headlight, Unscrew the two screws (spun down) that secure the upper part of the bumper.
-on the perimeter in the bottom part Unscrew the eight screws (spun up).
-for convenience wrenched the wheel depending on which way we will analyse it first.
-wheel arches pulled three pistons on each side and removed the fender liner.
-slide the wing flaps to the side and Unscrew one screw on each side holding the bumper corners to the wings.
-take out two of the pistons at the corners in the bottom grille of the bumper.
-with the assistant gently pulls the bumper itself.
-remove the connector from the fog lamp (if any).
-remove connector from the PDC (if any).
Rear bumper
-open the trunk lid.
-Unscrew the six screws opening.
-Unscrew the screws in the wheel arches (so as not to remove the wheels easier to turn a ratchet with a nozzle) that attach the fender liner.
-Unscrew the screws that attach the lower part.
-remove the fender liner to the side and Unscrew the screws holding the corners of the bumper to the wings.
-with the assistant pulls the bumper back.
-snap together the connectors of the equipment (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español