Front bumper

-open the hood.

-Unscrew the seven screws and take out the two clips that secure the grille and the upper bumper section.

-Unscrew the screws around the perimeter in the bottom (spun up).

-wrenched the wheel depending on which way we will analyse it first.

-wheel arches Unscrew the screws that secure the lining of the wings and wheel arches.

-free lining of the wings of the latches and Unscrew them under one screw on each side that attach the angles to the wings.

-with the assistant release the latch and gently pulls the bumper itself.

-remove the connector from the fog lamp (if any).

-remove connector from the PDC (if any).

seat mounting front bumper Ford Explorer V (after 2010)

the scheme of mounting front bumper Ford Explorer V (after 2010)

the scheme of mounting front bumper Ford Explorer V (after 2010)

Rear bumper

-open the trunk lid.

-in the opening, Unscrew the two screws.

-under plugs Unscrew two screws on each side that secure the tail lights.

-is released from the latch (pull to yourself) and remove the rear lights.

-Unscrew one screw on each side under the rear lights.

-Unscrew the screws and take out the pistons in the wheel arches (so as not to remove the wheels easier to turn a ratchet with a nozzle).

-free lining of the wings.

-under the covers, Unscrew the screws holding the corners of the bumper.

-Unscrew the screws (spun up) that secure the lower part.

-with the assistant release the latch and gently pulls the bumper back.

-releasable connector sensors.

the attachment of the rear bumper Ford Explorer V (after 2010)

the scheme of mounting the tail light, Ford Explorer V (after 2010)

scheme of fastening of a back bumper Ford Explorer V (after 2010)