-
-
-
Front bumper
-open the hood.
-remove the panel above the grille (if any).
-under the pickguard, Unscrew the screws and take out the clips that secure the grille and the upper bumper section.
-take out the caps and Unscrew the screws around the perimeter at the bottom.
-wrenched the wheel depending on which way we will analyse it first.
-wheel arches Unscrew the screws that attach the fender liner.
-for wheel arch liners Unscrew two screws on each side (spun upwards) holding the corners of the bumper to the wings.
-with the assistant release the latch and gently pulls the bumper itself.
-remove the connector from the fog lamp (if any).
-remove connector from the PDC (if any).
Rear bumper
-open the trunk lid.
-in the opening and pull out the caps and Unscrew the screws.
-Unscrew the screws in the wheel arches (so as not to remove the wheels easier to turn a ratchet with a nozzle).
-Unscrew two nuts on each side that attach the bumper to the wings.
-take out the rivets that attach the lower part.
-with the assistant gently pulls the bumper back.
-snap together the connectors of the equipment (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español