KIA Rio III UB / QB (2011-2017)

Depending on the model year and model type, the attachment is different.

Front bumper

 

-under the hood, take out four cap (the inserted top to bottom) that secure the cover.

-under the panel Unscrew the four screws (spun down) that secure the upper part of the bumper.

-take out the caps at the edges at the bottom.

-wrenched the wheel left or right, depending on which side of the bed will disassemble.

-wheel arches, peel the fender liner.

-unscrew one screw on each side (spun upwards) holding the corners to the wings.

-assistant free the bumper from the clips in the wings and under the headlights, pulled off the guides themselves. If clips the wings don't give in, you can Unscrew the screws (indicated by the blue arrow in the diagram) and remove bumper with brackets.

-remove the connector from the fog lamp (if any).

-remove the connector from the Parking assist sensors (if any).

-if you have headlight washers, disconnected the hoses (to prevent fluid from leaking on the ground, you should prepare a capacity).

the attachment of the front bumper KIA Rio III (2011-2017)

the scheme of fastening of the front bumper KIA Rio III (2011-2017)

the scheme of fastening of the front bumper KIA Rio III (2011-2017)

Rear bumper

 

Bumper removed together with the metal amp.

-in the opening of the trunk, under the covers, Unscrew the two screws on each side and remove the tail lights (hold on clips).

-(SALOON) in the side panels openable hatches and Unscrew four nuts on each side, remove rear lights.

-under the rear lights, unscrew the screws and take out the caps.

-wheel arches unscrew the screws that attach the fender liner.

-for wheel arch liners unscrew one screw on each side (spun upwards) holding the corners to the fenders (may not be).

-unscrew the screws and take out the caps at the bottom of the bumper.

-under the car, Unscrew three bolts on each side that secure the amplifier to the body.

-with the assistant release the latch (pull the corners away) and pulls the bumper itself.

-remove the connector from the Parking assist sensors (if any).

-remove the electrical connector license plate light.

the scheme of fastening of the rear bumper KIA Rio III (2011-2017) sedan

scheme of fastening of tail light KIA Rio III (2011-2017) hatchback

scheme of fastening of tail light KIA Rio III (after 2011) sedan

the scheme of fastening of the rear bumper KIA Rio III (2011-2017)

the scheme of fastening of the rear bumper KIA Rio III (2011-2017) hatchback

the scheme of fastening of the rear bumper KIA Rio III (2011-2017) sedan

 

How to remove front and rear bumper KIA Rio I (2000-2005)

How to remove front and rear bumper KIA Rio II (2005-2011)

How to remove front and rear bumper KIA Rio IV (2017+)