-
-
-
KIA Optima III / K5 TF (2010-2015)
Depending on the year of production and country of the manufacturer of the attachment may vary.
Front bumper
-open the hood.
-unscrew the screws and take out the caps, release the trim above the grille.
-unscrew the screws and take out the caps on the perimeter at the bottom.
-wrenched the wheel left or right, depending on which side of the bed will disassemble.
-wheel arches, peel the fender liner.
-attach the fender liner to the side and wrenched the screws (spun upwards) holding the corners to the wings.
-assistant release bumper latches and pulls from the guides themselves.
-remove the connector from the fog lamp (if any).
-remove the connector from the Parking assist sensors (if any).
-if you have headlight washers, disconnected the hoses.
Rear bumper
-in the trunk and remove the rear side trim.
-for casings, unscrew the nuts and remove the tail lights.
-the rear lights take out the caps and Unscrew the screws.
-for casings, unscrew the screws and take out the rivets that attach the bumper from the inside.
-unscrew the screws and take out the caps at the bottom of the bumper.
-in the wheel wells, unscrew the screws and peel the fender liner.
-attach the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners to the wings.
-with the assistant pulls the bumper from the guides themselves.
-remove the connector from the parking assist sensors (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español