Depending on the year of release of the attachment can vary.
-open the hood.
-Unscrew the screws and take out the rivets that attach the upper part (seven pieces).
-take out the caps and Unscrew the screws at the bottom (twisted and inserted from the bottom up).
-wrenched the wheel left or right, depending on which side of the bed will disassemble.
-wheel arches, peel the fender liner.
-Unscrew one screw on each side (spun upwards) holding the corners to the fenders
-assistant free the bumper from the clips in the wings and pulls itself.
-remove the connectors from the equipment (if any).
The bumper is removed together with the amplifier.
-in the opening of the trunk, Unscrew three screws on each side and remove the tail lights.
-the rear lights take out the caps.
-wheel arches Unscrew the screws that attach the fender liner.
-for wheel arch liners Unscrew one screw on each side (spun upwards) holding the corners to the wings.
-from under the car Unscrew two bolts on each side that attach the bumper reinforcement to the body.
-with the assistant release the latch in the wings and pulls the bumper itself.
-remove connector from the electrical equipment.