KIA Carnival (Sedona) II VQ (2006-2014)

Depending on the year of release of the attachment can vary.

Front bumper

-open the hood.

-take out thirteen clips and remove the trim above the grille.

-Unscrew two screws each side and remove the headlights.

-under the lights pulled by two clips on each side.

-on the perimeter in the lower part and pull out the caps (inserted from the bottom up).

-wrenched the wheel left or right, depending on which side of the bed will disassemble.

-wheel arches free the wheel arches and attach them to the side.

-for wheel arch liners Unscrew one screw on each side that attach the angles to the wings

-with the assistant pulls the bumper from the guides themselves.

-remove the connector from the fog lamp (if any).

-remove the connector from the Parking assist sensors (if any).

the attachment of the front bumper KIA Carnival (2006-2014)

the scheme of fastening of the front bumper KIA Carnival (2006-2014)

the scheme of fastening of the front bumper KIA Carnival (2006-2014)

Rear bumper

⇒Tips for removing bumpers and how to avoid breaking anything..⇐

-open the trunk lid.

-in the opening, Unscrew three screws on each side and remove the tail lights.

-under the rear lights, Unscrew the screws (spun down).

-Unscrew the screws (spun up) at the bottom of the bumper.

-wheel arches Unscrew the screws that attach the fender liner to the bumper.

-move the wing flaps to the side and Unscrew one screw on each side (spun upwards) holding the corners to the wings.

- with the assistant pulls the bumper itself.

-remove the connector from the Parking assist sensors (if any).

 the attachment of the rear bumper KIA Carnival (2006-2014)

the scheme of fastening of the rear bumper KIA Carnival (2006-2014)

 

How to remove front and rear bumper KIA Carnival (1999-2006)

How to remove front and rear bumper KIA Carnival (2014-2021)