-
-
-
Depending on the year of release of the attachment can vary.
Front bumper
-open the hood.
-take out four cap (the inserted top-down), in front of the radiator.
-Unscrew three screws on each side and remove the headlights.
-behind the headlights, the wings, Unscrew one screw on each side.
-on the perimeter in the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).
-wrenched the wheel left or right, depending on which side of the bed will disassemble.
-wheel arches free the wheel arches and attach them to the side.
-the fender liner, Unscrew the screws and take out the rivets that attach the angles to the wings
-with the assistant pulls the bumper from the guides themselves.
-remove the connector from the fog lamp (if any).
-remove the connector from the Parking assist sensors (if any).
Rear bumper
-open the trunk lid.
-in the opening and pull out the caps and Unscrew the screws that secure the top.
-in the opening of the trunk Unscrew two screws on each side and remove the tail lights.
-under the rear lights Unscrew one screw on each side.
-Unscrew the screws and take out the caps (inserted and spun up) in the lower part of the bumper.
-wheel arches free the wheel arches and attach them to the side.
-for wheel arch liners Unscrew one screw on each side (spun upwards) holding the angles to the wings.
-with the assistant pulls the bumper itself.
-remove the connector from the Parking assist sensors (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español