-
-
-
KIA Cerato II / Forte TD (2008-2013)
Depending on the model year and body type of attachment may vary.
Front bumper
The bumper is removed along with the grille.
-open the hood.
-take out the four clips that secure the grille (inserted upside down).
-on the perimeter in the lower part and pull out the caps (inserted from the bottom up).
-wrenched the wheel left or right, depending on which side of the bed will disassemble.
-wheel arches free the wheel arches and attach them to the side.
-for wheel arch liners unscrew one screw on each side that attach the angles to the wings.
-with the assistant release the latch in the wings and under the headlights.
-pulls the bumper from the guides themselves.
-remove the connector from the fog lamp (if any).
-remove the connector from the Parking assist sensors (if any).
Rear bumper
-open the trunk lid.
-in the side panels openable hatches (to gain access to the rear part of the rear lights).
-under the hatch unscrew three nuts on each side and remove the tail lights.
-under the rear lights, unscrew the screws (spun up).
-remove the plastic cover of the rear panel.
-the casing unscrew the four screws that secure the amplifier bumper to the body.
-unscrew the screws in the opening of the trunk (may not be).
-wheel arches, peel the fender liner.
-attach the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners to the wings.
-with the assistant release the latch in the wings and pulls the bumper itself.
-remove the connector from the Parking assist sensors (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español