Depending on the model year and model type, the attachment may vary.

Front bumper

-open the hood.

-take out the caps and in the opening between the headlights.

-Unscrew the screws around the perimeter at the bottom.

-wrenched the wheel left or right, depending on which side of the bed will disassemble.

-in the wheel wells, Unscrew the screws and peel the fender liner.

-attach the fender liner to the side and wrenched the screws (spun upwards) holding the corners to the fenders

-with the assistant pulls the bumper from the guides themselves.

-remove the connector from the fog lamp (if any).

-remove the connector from the Parking assist sensors (if any).

the attachment of the front bumper KIA Rio I (2000-2005)

the scheme of fastening of the front bumper KIA Rio I (2000-2005)

Rear bumper

-(depending on body type) remove rear lights and Unscrew the screws under them (twisted upside down).

-in the opening of the trunk take out the caps.

-wheel arches Unscrew the screws that attach the fender liner.

-for wheel arch liners Unscrew one screw on each side (spun upwards) holding the corners to the wings.

-Unscrew the screws and take out the caps at the bottom of the bumper (may not be).

- with the assistant pulls the bumper itself.

-remove the electrical connector license plate light.

-remove the connector from the Parking assist sensors (if any).

the attachment of the rear bumper KIA Rio I (2000-2005)

the scheme of fastening of the rear bumper KIA Rio I (2000-2005)