Depending on the year of release of the attachment can vary.

Front bumper

-under the hood, Unscrew the screws (spun down) that secure the upper part.

-in the lower part pulls out nine of the caps (inserted from the bottom up).

-wrenched the wheel left or right, depending on which side of the bed will disassemble.

-wheel arches, peel the fender liner.

-for wheel arch liners Unscrew one screw on each side (spun upwards) holding the corners to the fenders

-with the assistant release the latch and pulls the bumper itself.

-remove the connector from the fog lamp (if any).

-remove connector from the PDC (if any).

-if you have headlight washers, disconnected the hoses (be aware that will drain the fluid).

the attachment of the front bumper KIA Sportage KM (2004-2010)

the scheme of fastening of the front bumper KIA Sportage KM (2004-2010)

Rear bumper

-in the opening of the trunk Unscrew two screws on each side and remove the tail lights (hold on clips).

-the rear lights take out two pistons and twisted in the opening of the trunk with one screw on each side.

-wheel arches Unscrew the screws that attach the fender liner.

-free lockers and Unscrew one screw on each side (spun upwards) holding the corners to the wings.

-on the perimeter in the lower part and pull out the caps (inserted from the bottom up)..

-with the assistant release the latch and pulls the bumper from the guides themselves.

-remove the connectors from the sensors (if any).

the attachment of the rear bumper KIA Sportage KM (2004-2010)

scheme of fastening of tail light KIA Sportage KM (2004-2010)

the scheme of fastening of the rear bumper KIA Sportage KM (2004-2010)