-
-
-
Depending on the model year and body type of attachment may vary.
Front bumper
-open the hood.
-take out the caps and remove the strip over the grille.
-under the pickguard, Unscrew the screws (spun down).
-on the perimeter in the lower part and pull out the caps (inserted from the bottom up).
-wrenched the wheel left or right, depending on which side of the bed will disassemble.
-wheel arches free the wheel arches and attach them to the side.
-for wheel arch liners Unscrew one screw on each side that attach the angles to the wings.
-with the assistant release the latch in the wings and pulls the bumper from the guides themselves.
-remove the connector from the fog lamp (if any).
-remove the connector from the Parking assist sensors (if any).
Rear bumper
-in the side panels of the trunk opening hatches (to gain access to the rear part of the rear lights).
-under the hatches, Unscrew four nuts on each side and remove the tail lights.
-under the rear lights pulled three pistons on each side (inserted upside down).
-Unscrew one screw on each side in the doorway of the trunk.
-Unscrew the screws and take out the caps (twisted and inserted from the bottom up) in the lower part of the bumper.
-wheel arches Unscrew the screws that attach the fender liner to the bumper (so as not to remove the wheels, use a ratchet with a nozzle).
-move the wing flaps to the side and Unscrew one screw on each side (spun upwards) holding the corners to the wings.
-with the assistant release the latch in the wings and pulls the bumper itself.
-remove the connector from the Parking assist sensors (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español