How to remove front and rear bumper KIA Opirus (Amanti)

Depending on the year of release of the attachment can vary.

Front bumper

-open the hood.

-Unscrew the four screws near the headlights (spun down).

-take out the two clips under the grille.

-Unscrew the screws and take out the caps on the perimeter at the bottom.

-wrenched the wheel left or right, depending on which side of the bed will disassemble.

-wheel arches, peel the fender liner.

-attach the fender liner to the side and wrenched the screws (spun upwards) holding the corners to the fenders

-with the assistant pulls the bumper from the guides themselves.

-remove the connector from the fog lamp (if any).

-remove the connector from the Parking assist sensors (if any).

Rear bumper

-in the opening of the trunk remove the trim.

-remove rear and side trim.

-for casings, Unscrew the nuts and remove the tail lights.

-under rear lights and opening boot take out the caps.

-in the trunk, Unscrew the screws that attach the bumper to the wings.

-Unscrew the screws and take out the caps at the bottom of the bumper.

-in the wheel wells, Unscrew the screws and peel the fender liner.

-attach the fender liner to the side and Unscrew one screw on each side (spun upwards) holding the corners to the wings.

-with the assistant pulls the bumper from the guides themselves.

-remove the connector from the Parking assist sensors (if any).