-
-
-
Depending on the year of release of the attachment can vary.
Front bumper
-if you have the headlight washers, pull the nozzle up and remove the cover.
-under the hood, Unscrew three screws on each side and remove the headlights.
-behind the headlights, Unscrew one nut on each side that attach the bumper to the wings.
-take out the clips and remove the trim above the radiator.
-in the opening between the headlights pulls out eight rivets and remove the plate.
-under the panel and pull out the clips fastening the top.
-take out the caps and Unscrew the screws at the bottom (twisted and inserted from the bottom up).
-wrenched the wheel left or right, depending on which side of the bed will disassemble.
-wheel arches, peel the fender liner.
-Unscrew the screws (spun upwards) holding the corners to the fenders
-Unscrew the screws in the lower grille.
-with the assistant pulls the bumper itself.
-remove the connectors from the equipment (if any).
Rear bumper
-in the opening of the trunk Unscrew two screws on each side and remove the tail lights.
-the rear lights take out two pistons on each side.
-in the opening of the trunk, Unscrew the screws and take out the caps.
-in the trunk, side panels, below the rear light, open the access doors (fastened by rivets or screws).
-for hatches Unscrew two nuts from each side.
-wheel arches Unscrew the screws that attach the fender liner.
-for wheel arch liners Unscrew one screw on each side (spun upwards) holding the corners to the wings.
-Unscrew the screws around the perimeter at the bottom.
-with the assistant release the latch in the wings and pulls the bumper itself.
-remove connectors from electrical equipment.
English 
Italiano 
Français 
русский 
Deutsch 
Español