-
-
-
KIA Carnival (Sedona) III YP (2014-2021)
Depending on the year of manufacture, the attachment points may vary slightly.
Front bumper
-open the hood.
-under the hood take out nine caps and remove the trim over the top of the bumper.
-under the trim, unscrew the four screws.
-on the perimeter of the lower part, unscrew the nine screws (spun up).
-turn the wheels to the side.
-wheel arches take out four pistons on each side that secure the fender liner (front).
-move the fender liner to the side and unscrew one screw on each side (spun up) that secure the corners of the bumper to the wings.
-we release the latch in the wings (pull the corners of the bumper towards you).
-with an assistant, pull the bumper forward (look behind the wires and hoses).
-disconnect electrical connectors.
Rear bumper
-open the trunk lid.
-remove the pads near the rear lights (hold on snaps, you need to pry).
-unscrew two screws on each side and remove the tail lights.
-under the rear lights take out two pistons.
-at the bottom of the bumper, unscrew the nine screws (caps).
-in the wheel wells, unscrew three screws on each side that secure the fender liner (rear).
-uscrew one screw on each side that attach the corners of the bumper to the wings.
-we release the latch in the wings (pull the corners of the bumper towards you).
-with an assistant, pull the bumper back (look for the wires).
-disconnect electrical connectors.
English 
Italiano 
Français 
русский 
Deutsch 
Español