Audi e-tron I (2018+)
Depending on the year of manufacture, the attachment points may vary slightly.
Front bumper
-open the hood.
-under the hood, remove the lining.
-under the trim, unscrew the two screws (spun up).
-depending on which side we will disassemble, turn the wheels.
-remove the lining of the arches (hold on the latches, you need to pry and pull towards you).
-in the wheel wells, unscrew three screws on each side that secure the fender liner (front).
-unscrew one screw on each side that attach the corners of the bumper to the wings.
-unscrew the screws (spun up) from the bottom.
-we release the latch in the wings (pull the corners towards you).
-we release the latches under the headlights.
-with an assistant, pull the bumper forward (look behind the wires and hoses).
-disconnect the headlight washer hoses (liquid may leak).
-disconnect electrical connectors.
Rear bumper
-open the trunk lid.
-remove the pads near the rear lights (hold on latches, pull towards you).
-unscrew two screws on each side and remove the rear lights (held by snaps in the wings).
-under the rear lights, unscrew the two screws and pull up the two plastic clips.
-in the trunk, remove the rear panel trim and unscrew the four nuts behind it (you need a socket with an extension).
-from the bottom, unscrew the screws (spun up).
-remove the lining of the arches (hold on the latches, you need to pry and pull towards you).
-in the wheel wells, unscrew three screws on each side that secure the fender liner (rear).
-unscrew one screw on each side that attach the corners of the bumper to the wings.
-we release the latch in the wings (pull the corners of the bumper towards you).
-we release the latches under the rear lights.
-with an assistant, pull the bumper back (look for the wires).
-disconnect electrical connectors.