English 
Italiano 
Français 
русский 
Deutsch 
Español Audi A6 IV C7 (2011-2018)
Front bumper
The bumper is removed along with the grille.
Depending on the model year and model type, the attachment is slightly different.
-wrenched the wheel to the left or right side depending on which side we will analyze first.
-in the wheel wells, Unscrew the screws and take out the rivets that attach the fender liner.
-move the wing flaps to the side and unscrew one screw on each side (twisted up) in the corners and one screw under the headlights (will need a head with a nozzle).
- behind the left inner fender switched the hoses of the headlight washer system. The liquid leaking on the ground, you need to prepare a suitable container or tube.
-under the hood, take out the clips and remove the trim above the radiator grille.
-unscrew the screws under the panel (spun down).
-unscrew the screws around the perimeter in the bottom (spun up).
-with the aide of tear the corners with the locks in the wings and pulls the bumper from the guides themselves.
-remove connector from the PDC.
-remove the connector from the fog lamp (if any).
-remove connectors with additional electrical equipment (if available, depending on the equipment of car).
Rear bumper
-in the opening of the trunk, remove the lining of the rear lights (mounted on the latches).
under the covers unscrew two nuts from each side.
-attach the lights to the sides and release the latches.
-under the rear lights unscrew one screw on each side and in the corners, between the bumper and the wing, remove the locking pins.
-unscrew the screws in the wheel arches that secure the wheel arches (not to remove the wheel, remove ratchet with a nozzle).
-unscrew the screws around the perimeter in the bottom (spun up).
-assistant free the bumper from the clips in the wings and pulled off of the guide itself-if there are sensors remove connector (located under the skin in the trunk).
-remove connectors with additional equipment (depending on equipment of car).
