How to remove front and rear bumper Audi Q5 (2008-2017)

Audi Q5 I 8R (2008-2017)

Front bumper

The bumper is removed along with the grille.

Depending on the model year and model type, the attachment is slightly different.

-under the hood take out the six rivets (inserted upside down) and remove the cover over the grille.

-under the lid, unscrew one screw on each side near the headlights (spun down) that secure the upper part of the bumper.

-unscrew the screws on the perimeter in the bottom (spun up).

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-wheel arches Unscrew the screws that attach the fender liner.

-with the aide of tear the corners with the locks in the wings and pulls the bumper from the guides themselves.

-if you have headlight washers, detach the hoses from the injectors. The liquid leaking on the ground, you need to prepare a suitable container or tube.

-remove connector from the PDC.

-remove the connector from the fog lamp (if any).

-remove connectors with additional electrical equipment (if available, depending on the equipment of car).

Rear bumper

-in the trunk, upwards, remove the rear trim panel (sits very tight).

-under the skin, in the corners, Unscrew two nuts on each side (will need head ratchet).

-unscrew the screws in the wheel arches that secure the wheel arches (not to remove the wheel, remove ratchet with a nozzle).

-unscrew the screws around the perimeter in the bottom (spun up).

-take out one piston on each side under the rear lights (may not be).

-assistant free the bumper from the clips in the wings and pulled off of the guide itself.

-if you have sensors, remove the plug (located under the skin in the trunk).

-remove connectors with additional equipment (depending on equipment of car).

How to remove front and rear bumper Audi Q5 II (2017+)