How to remove front and rear bumper Audi Q3 II

Audi Q3 II F3 (2018+)

Front bumper

-open the hood.

-under the hood, remove the trim over the grille.

-under the trim, unscrew the screws (spun down).

-depending on which side we will disassemble, turn the wheels.

-we release the lining of the arches from the bumper (hold on the latches, you need to pry and pull towards you).

-in the wheel wells, unscrew the screws that secure the fender liner (front) and bumper corners to the wings.

-unscrew the screws (spun up) from the bottom.

-we release the latch in the wings (pull the corners towards you).

-we release the latches under the headlights.

-with an assistant, pull the bumper forward (look behind the wires and hoses).

-disconnect the headlight washer hoses (liquid may leak).

-disconnect electrical connectors.

Rear bumper

-open the trunk lid.

-in the trunk, remove the rear panel trim.

-for the casing, unscrew the four nuts (you need a socket with an extension).

-from the bottom, unscrew the screws (spun up).

-in the wheel wells, unscrew the screws that secure the fender liner (rear).

-we release the lining of the arches from the bumper (hold on the latches, you need to pry and pull towards you).

-unscrew one screw on each side that attach the corners of the bumper to the wings.

-we release the latch in the wings (pull the corners of the bumper towards you).

-with an assistant, pull the bumper back (look for the wires).

-disconnect electrical connectors.

How to remove front and rear bumper Audi Q3 I