Front bumper

-open the hood and take out the caps (inserted from top to bottom) that secure the top part of the bumper (to get the clips you need to push it a Central part inside until you hear a click)

-Unscrew the screws at the bottom (spun up).

-wrenched the wheel to the left or right side depending on which side we will analyze first.

-in the wheel wells, Unscrew the screws holding the wheel arches and moldings on the wings.

-move the wing flaps to the side and Unscrew the screws that attach the angles to the wings.

-with the aide of tear corners with latches and pulls the bumper from the guides themselves.

-remove connector from the PDC (if any).

-remove the connector from the fog lamp.

-if you have headlight washers, disconnected the hoses. The liquid leaking on the ground, you need to prepare a suitable container or tube.

Rear bumper

-open the boot lid and Unscrew the aperture screws (spun down).

-Unscrew the screws in the wheel arches that secure the wheel arches and moldings on the fenders to the bumper (so as not to remove the wheel, remove ratchet with a nozzle).

-move the wing flaps to the side and Unscrew one screw on each side (may not be).

-Unscrew the screws around the perimeter in the bottom (spun up).

-assistant free the bumper from the clips in the wings and pulled off of the guide itself.

-remove connectors from Parking assist sensors (if any).