How to remove front and rear bumper Mazda 6 (2008-2012)

Mazda 6 II (GH) (2008-2012)

Depending on the year of manufacture, body type and country of the manufacturer of the attachment are slightly different.

Front bumper

The bumper is removed along with the grille.

-under the hood, Unscrew the screws and take out the caps (twisted and inserted upside down).

-on the perimeter in the bottom part Unscrew twelve screws (spun up) that secure the protection of the engine and the fender liner to the bumper.

-wrenched the wheel left or right, depending on which side of the bed will disassemble.

-wheel arches pulled three pistons and Unscrew one screw on each side holding the fender liner.

-with the assistant release the latch in the wings (on both sides of the headlights).

-remove the bumper from the guides themselves.

-remove the connector from the fog lamp.

-disconnected the connector of the Parking aid (if any).

-switched the hoses of the headlight washer system (if any). The liquid leaking on the ground, is to prepare the container or tube.

Rear bumper

-in the trunk remove the trim panel (need to access the rear part of the rear lights).

-for casings Unscrew three nuts on each side and remove the tail lights.

-under the rear lights Unscrew one screw (can be caps).

-take out the caps and Unscrew the screws at the bottom of the bumper (twisted and inserted from the bottom up).

-Unscrew the screws in the wheel arches, free lockers (so as not to remove the wheels easier to turn a ratchet with a nozzle).

-with the assistant release the latch in the wings (pull the corners to the sides) and opening the trunk.

-remove the bumper from the guides themselves.

-remove the connector from the Parking aid sensors (if any).

How to remove front and rear bumper MAZDA 6 (2002-2008)

How to remove front and rear bumper Mazda 6 (2013-2022)