How to remove front and rear bumper Mazda 5 (2010-2018)

Mazda 5 III CW (2010-2018), Mazda Premacy III CW (2010-2018).

Front bumper

-open the hood.

-under the hood, unscrew the two screws and take out four of the pistons (spun down).

-on the perimeter in the bottom part Unscrew ten screws (spun up).

-wrenched the wheel left or right, depending on which side of the bed will disassemble.

-wheel arches pulled three pistons on each side that attach the fender liner.

-move the wing flaps to the side and Unscrew one screw on each side which attach the corners of the bumper to the wings (spun up).

-with the assistant release the latch in the wings.

-remove the bumper from the guides themselves.

-remove the connector from the fog lamp.

-remove the connector from the Parking aid sensors (if any).

-switched the hoses of the headlight washer system (if any).The liquid leaking on the ground, is to prepare the container or tube.

Rear bumper

-open the trunk lid.

-in the opening of the trunk, unscrew the four screws.

-take out the caps at the bottom of the bumper (inserted from the bottom up).

-unscrew the screws in the wheel arches, free lockers (to remove the wheels easier to turn the ratchet with the extension).

-with the assistant release the latch in the wings (pull the corners to the sides) and remove the bumper from the guides themselves.

-remove the connector from the Parking aid sensors (if any).

How to remove front and rear bumper MAZDA 5 (2005-2010)