How to remove front and rear bumper MAZDA 6 (2002-2008)

Front bumper

-open the hood and Unscrew the two screws (spun down).

-on the perimeter in the bottom part Unscrew the screws and take out the caps (twisted and inserted from the bottom up).

-wrenched the wheel left or right, depending on which side of the bed will disassemble.

-wheel arches pulled three pistons on each side that attach the fender liner.

-move the wing flaps to the side and Unscrew one screw on each side holding the corners of the bumper to the wings (spun up).

-with the assistant release the latch in the wings (pull the corners apart).

-remove the bumper from the guides themselves.

-remove the connector from the fog lamp.

-disconnected the connector of the Parking aid (if any).

-switched the hoses of the headlight washer system (if any). The liquid leaking on the ground, is to prepare the container or tube.

Rear bumper

-in the boot remove the side trim (you need to access the rear part of the rear lights).

-for casings Unscrew two nuts from each side and remove the tail lights.

-under the rear lights Unscrew one screw and take out one piston on each side.

-take out the caps and Unscrew the screws at the bottom of the bumper (twisted and inserted from the bottom up).

-Unscrew the screws in the wheel arches, free lockers (to remove the wheels easier to turn the ratchet with the extension).

-move the wing flaps to the side and Unscrew one screw on each side (spun upwards) holding the corners to the wings.

-with the assistant release the latch in the wings (pull the corners to the sides) and remove the bumper from the guides themselves.

-remove the connector from the Parking aid sensors (if any).

How to remove front and rear bumper Mazda 6 (2008-2012)

How to remove front and rear bumper Mazda 6 (2013-2022)