How to remove front and rear bumper MAZDA 5 (2005-2010)

Mazda 5 CR (2004-2010), Mazda Premacy II CR (2004-2010).

Front bumper

-open the hood.

-unscrew the screws and take out the caps (twisted and inserted top to bottom) that secure the upper part.

-unscrew the screws and take out the clips around the perimeter in the bottom (twisted and inserted from the bottom up).

-wrenched the wheel to the side.

-wheel arches pulled three pistons on each side, peel the fender liner.

-attach the fender liner to the side and Unscrew one screw on each side holding the corners of the bumper to the wings (spun up).

-with the assistant release the latch in the wings.

-remove the bumper from the guides themselves.

-remove the connector from the fog lamp (if any).

-remove the connector from the Parking aid sensors (if any).

-switched the hoses of the headlight washer system (if any). The liquid leaking on the ground, is to prepare the container or tube.

Rear bumper

-open the trunk lid.

-in the opening, Unscrew one screw on each side, below the rear lights.

-unscrew the screws and take out the caps at the bottom of the bumper (twisted and inserted from the bottom up).

-unscrew the screws in the wheel arches, free lockers (to remove the wheels easier to turn the ratchet with the extension).

-the wing flaps in the corners, Unscrew one screw on each side (spun up).

-with the assistant release the latch in the wings and opening the trunk, remove the bumper from the guides themselves.

-remove the connector from the Parking aid (if any).

How to remove front and rear bumper Mazda 5 (2010-2018)