Mazda 2 III (DJ) (2014-2022), Mazda Demio (2014-2019)
Depending on the year of manufacture and body type, the attachment points differ slightly.
-open the hood.
-under the hood take out two pistons and unscrew the four bolts that secure the upper part of the bumper.
-around the perimeter of the lower part, unscrew the screws and take out the caps (twisted and inserted from the bottom up) that secure the engine protection and fender liner.
-we release the front part of the engine protection from the bumper and unscrew the screws behind it.
-turn the wheels to the side.
-wheel arches take out three pistons on each side that secure the fender liner (front).
-move the fender liner to the side and unscrew one screw on each side (spun up) that attach the corners of the bumper to the wings.
-we release the latches in the wings (pull the corners of the bumper towards you) and the clips in the front of the bumper.
-with an assistant, pull the bumper forward (look for the wires).
-disconnect electrical connectors (if any).
-open the trunk lid.
-(SEDAN) remove the rear lights.
-in the opening of the trunk, unscrew the four screws.
-in the wheel arches, unscrew the screws and take out the caps that secure the fender liner (rear) and bumper corners to the wings.
-around the perimeter of the lower part of the bumper, take out the caps and unscrew the screws (inserted and unscrewed from the bottom up).
-we release the latch in the wings (pull the corners of the bumper towards you).
-with an assistant, pull the bumper back (look for the wires).
-disconnect electrical connectors.