Depending on the model year and body type of the attachment points are slightly different.
Front bumper
-open the hood.
-under the hood, Unscrew the two screws and take out the three clips that secure the upper part.
-around the bottom part Unscrew the screws.
-remove the license plate.
-under the license plate, Unscrew the screws (may not be).
-depending on which side we will disassemble, wrenched the wheel.
-in the wheel wells, Unscrew the screws, remove the caps and removed the wheel arch liners (you can not fully remove).
-through the wheel arches in the wings, you have to turn 90 degree clamps. This requires a special tool that can make your own from steel wire (see picture).
-we release the latch in the wings (pull the corners themselves).
-pulls the bumper forward (don't want to break the wires and hoses).
-remove the connectors from the fog lights (if any).
-(if any) disconnected hoses to the washer (can leak fluid).
Rear bumper
-open the trunk lid.
-(if any) in the opening of the trunk, Unscrew the screws.
-remove tail lights.
-under the rear lights Unscrew one nut on each side.
-in the trunk remove the hatches in the side panels (need to access the inner part of the wings).
-through the openings of the doors, Unscrew the screws in the wings.
-in the wheel wells, Unscrew the screws and peel the fender liner (you can not fully remove).
-for wheel arch liners Unscrew one screw on each side holding the bumper corners to the wings.
-from the bottom Unscrew the nut.
-with an assistant, carefully (don't want to break the wires) pulls the bumper back.
-remove the connectors from the equipment (if any).