-
-
-
Front bumper
-open the hood.
-under the hood take out the caps and Unscrew the screws (inserted and twisted from top to bottom) that secure the upper part.
-we release the top part of the latches (at the places indicated by the arrows to push with a flat head screwdriver).
-around the bottom part Unscrew the screws (spun up).
-depending on which side we will disassemble, wrenched the wheel.
-wheel arches, peel the fender liner.
-for wheel arch liners Unscrew one screw on each side (twisted upside down) holding the corners of the bumper to the wings.
-we release the latch in the wings (pull the corners themselves).
-pulls the bumper forward (don't want to break the wires and hoses).
-remove the connectors from the fog lights (if any).
-switched the hoses to the washer (can leak fluid).
Rear bumper
-open the trunk lid.
-from the trunk, Unscrew the plastic nuts and remove the tail lights.
-the rear lights take out the caps and turn 90 degrees the clips.
-Unscrew the screws and take out the rivets that secure the lower part of the (twisted and inserted from the bottom up).
-wheel arches, peel the fender liner.
-for wheel arch liners Unscrew one screw on each side that attach the angles to the wings (spun down).
-remove the back bumper (don't want to break the wires).
-remove the connectors from the equipment (if any).
English 
Italiano 
Français 
русский 
Deutsch 
Español