Depending on the model year and body type of the attachment points are slightly different.

Front bumper

-open the hood.

-under the hood, Unscrew the screws and take out the rivets that secure the pad.

-Unscrew the screws that secure the top.

-around the bottom part Unscrew the screws holding the lower part.

-depending on which side we will disassemble, wrenched the wheel.

-in the wheel wells, Unscrew the screws and peel the fender liner (you can not fully remove).

-the fender liner, Unscrew the screws that attach the angles to the wings.

-we release the latch in the wings (pull the corners themselves).

-pulls the bumper forward (don't want to break the wires and hoses).

-remove the connectors from the fog lights.

-(if any) disconnected hoses to the washer (can leak fluid).

the attachment of the front bumper of Peugeot 508

the scheme of fastening of the front bumper of Peugeot 508

Rear bumper

-in the trunk in the side panels remove the cap.

-for plugs Unscrew the nuts that attach the rear lights.

-take out a rear light.

-Unscrew the screws that secure the top.

-wheel arches free lockers (you can not fully remove).

-the fender liner, Unscrew the screws holding the corners of the bumper to the wings.

-Unscrew the screws that attach the lower part (spun up).

-we release the latch in the wings (pull the corners themselves).

-with an assistant, carefully (don't want to break the wires) pulls the bumper back.

-remove  connectors from electrical equipment.

the attachment of the rear bumper of Peugeot 508

the attachment of the rear bumper of Peugeot 508

the scheme of fastening the rear bumper of Peugeot 508

the scheme of fastening the rear bumper of Peugeot 508