Depending on the model year and body type of the attachment points are slightly different.
Front bumper
-open the hood.
-under the hood take out the caps (can be screws) and remove upward the radiator grille.
-under the grille, Unscrew the screws and release the latches.
-Unscrew three screws on each side and remove lights (depending on year and engine, can interfere with the battery and washer fluid reservoir).
-behind the headlights, the wings need to rotate 90 degree clamps
-around the bottom part Unscrew the screws.
-depending on which side we will disassemble, wrenched the wheel.
-wheel arches free lockers (you can not fully remove).
-for wheel arch liners Unscrew one screw on each side holding the bumper corners to the wings.
-pulls the bumper forward (don't want to break the wires and hoses).
-remove the connectors from the fog lights (if any).
-(if any) disconnected hoses to the washer (can leak fluid).
Rear bumper
-open the trunk lid.
-in the trunk and remove the rear side trim.
-for casings, Unscrew the six screws (two under the rear lights and one in the wings on each side).
-in the wheel wells, Unscrew the screws and peel the fender liner (you can not fully remove).
-for wheel arch liners Unscrew one screw on each side holding the bumper corners to the wings.
-from the bottom Unscrew the screws that attach the lower part (spun up).
-with an assistant, carefully (don't want to break the wires) pulls the bumper back.
-remove the connectors from the equipment (if any).